Tel:86-574-82813566
86-574-87362469
86-574-87171029
Address:No.201,Xinlian Road,GaoQiao town,Yinzhou district,Ningbo,China
Email: wf.chen@dfjrsb.com
How to clean electric furnace fan
Blower your electric furnace of the most neglected part of one. electric furnace many people just do not give the blower blower second thought, until it stopped working. You can take time out to clean up the blower to avoid the problem of the furnace blower. When you change the furnace filter, clean furnace blower. Cleaning only takes a few minutes, but it can save you hundreds of dollars for repairs.
1 Turn off the power supply, electric stove. There is a red emergency off switch, it looks like an ordinary light switch near the furnace. Rotary switch to the off position. You should also open the circuit breaker to the furnace. The circuit breaker in your home's electrical panel.
2 Remove the blower compartment access door. Doors most often brought from the furnace. Some manufacturers require you to remove the two screws Phillips head screwdriver in the top panel.
3 pull furnace filter away from the filter area close to the blower. You should replace the filter every three months.
4 open cage, furnace blower wheel to reach your hand. continuous furnace remove any large amount of dust accumulation and throw garbage debris. The round will collect dust and debris in the surrounding, the wall behind the wheel.
Vacuum cleaners and interior brush blower wheel. The wheels of the vacuum inside and outside the fan assembly. Wire around the clean-up carefully, so you do not accidentally break or disconnect any wires.
6 Check that the fan wheel fins fins stick dirt accumulation. Dust and dirt adhere to the fins affect the operation of the fan wheel.
7 Remove the two screws fan assembly furnace with a socket wrench. The screw in front of the furnace blower assembly. Blower Assembly enough, you can use a toothbrush to clean fins.
Brush toothbrush fins away from dust and dirt. Pay special attention to the end of the fins, they met the side of the wheel. Vacuum debris and slide into the furnace blower assembly back. Fixed and fixed screw furnace blower assembly.
9 Industrial oven replaced by a new furnace filters and filter installation into the furnace. Re-blower compartment access door. Turn the power to the furnace.
